DKSH India Specialty Chemicals Industry

HARDLEN® CY-9122P is an adhesion promotor for difficult plastic such as polyolefin.

HARDLEN F-6P is an adhesion promotor for difficult plastic such as polyolefin.

HARDLEN® PMA-L is widely used as an adhesion promoter to PP substrate. This grade is chlorine-free environmentally friendly type. It has good adhesion to polypropylene substrates and easy to be melted on substrates at low temperature.

STEPSPERSE® 61 is a VOC-free, high-performance polymeric dispersant and wetting agent for waterborne formulations. It is highly effective for dispersing and stabilizing organic pigments and carbon black. Dispersions prepared with STEPSPERSE® 61 exhibit excellent compatibility with various resin systems with a minimal impact on coating properties.

ITAMID WATER 512 is developed to be cured with liquid epoxy resin or with epoxy resin emulsion/dispersion in water.

ITAPOX WATER 110 is a dispersion of solid epoxy resin in water solution with a 52% solid content. The product contains a minimum quantity of organic solvents and is developed to be used for low VOC waterborne epoxy coatings. The product features good compatibility with waterborne curing agents such as ITAMID WATER 512, ITAMINE WATER 2157 and ITAMINE WATER 1419.

Luna CMC 5000 A is a purified, high viscosity sodium carboxymethyl cellulose, based on sustainably-sourced cellulose.

229-6420, Perrindo® Red 224 is high chroma Perylene red pigment toner with excellent transparency and cleanliness, good rheological properties to allow for high pigment loadings in high solid resin systems.

SYNTEVEN 404 is a similar to Synteven 440, but more reactive. Very easy to sand. Suggested also with CHPO.

TEXIPOL®63-202 is an inverse emulsion thickener that imparts pseudoplastic rheology to aqueous-based compositions. TEXIPOL 63-202 can be used to thicken a wide variety of aqueous binder systems including; PVA, VAE, SBR, PVdC, and acrylic and styrene-acrylic copolymers. It has been used in various adhesive, sealant, and coating formulations. It can thicken systems as low as pH 5 but is most efficient at pH>7. Typical thickener dosages are probably 0.5-2.0%, though this is system-dependent and higher paste viscosities may require higher addition levels.