Specialty Chemicals

SETATHANE D 1150 is applied in the formulation of tough-elastic coatings. It is used in combination with other polyols such as SETATHANE D 1145, 1155 and crosslinked with Desmodur® VL, SETATHANE D 1150 is suitable for use in the formulation of two-component coatings. These are mainly used on concrete and asphalt floors and steel surfaces. After crosslinking and curing of SETATHANE D 1150 with Desmodur VL, the resultant coatings are tough and flexible, hard-wearing and hemicalresistant. It can also be combinedwith Desmodur L to formulate highly resistant sealing compounds.

SETATHANE D 1145 is applied in the formulation of hard and tough coatings and synthetic resin mortars.It is used in combination with other polyols such as SETATHANE D 1150 and crosslinked with Desmodur VL, SETATHANE D 1145 is suitable for use in the formulation of two-component coatings. The main applications are in the construction industry. Curing yields hard to tough but flexible films which are resistant to abrasion and chemicals. In combination with other polyols such as SETATHANE D 1150 and crosslinked with Desmodur VL, SETATHANE D 1145 is suitable for use in the formulation of two-component coatings. The main applications are in the construction industry. Curing yields hard to tough but flexible films which are resistant to abrasion and chemicals.

ROSKYDAL K 27/1 is a binder for highly filled knifing fillers and stoppers for marble and stone. Fillers based on ROSKYDAL K 27/1 cure fully whether applied in thin or thick coats. They are used in applications requiring hard adhesives and fillers. Formulation Combinations of talc, dolomite/calcite and powdered barytes with low iron content have proved suitable as extenders, with talc as the main component because it improves the adhesion to the substrate. The more spherical extenders such as dolomite, chalk and barytes ensure dense packing.

ROSKYDAL K 60 is a binder for highly filled, coarse and fine knifing fillers with long potlife. ROSKYDAL K 60 enables formulation of fillers with long potlife of 30-45 min. using the standard hardener Di-Benzoylperoxide. ROSKYDAL K 60 is also suitable for fillers with overbaking resistance at temperatures up to 170°C. Fillers based on ROSKYDAL K 60 cure fully when applied in both thin and thick coats.They can be made harder by the addition of e.g. ROSKYDAL K 14 M or ROSKYDAL K 36. Formulation Talc, dolomite/calcite and powdered barytes with low iron content have proven suitable as extenders, with talc as the main component because it improves the adhesion to the substrate. Only coarse and blended talcs should be used to formulate fillers with overbaking resistance up to 170°C.