S-06E is an electronic grade epoxy. It can be used as a casting resin, in LED encapsulation, insulating materials, 3D printing, carbon fibre cable cores and other composite materials, giving outstanding performance for UV resistance and anti-radiation properties. It is UV curable, thermal curable with anhydrides, high TG up to 195ºC, excellent yellowing resistance and good UV resistance, outstanding electrical insulation, low halogen and high purity and low viscosity.

S-21 is a distilled base epoxy resin for use in formulating UV-curable cycloaliphatic epoxide coatings systems. S-21 contributes to primary film properties. S-21 has both carboxylate and epoxy groups, with the potential for fast cure. S-21 is widely used in industry for the preparation of inks, resins, coatings, and encapsulation.

BECKOCURE EH 2260W/41WA is an hydrophobic amine hardener especially for the formulation of waterborne metal coatings, free of volatile basic amines and solvents. In combination with epoxy dispersions fast drying Primers and Monocoats with excellent corrosion protection and very good non-sagging properties can be formulated. The product shows excellent application behaviour and a very robust performance even on poorly prepared surfaces. Beckocure EH 2260w is used together with solid epoxy resin dispersions or emulsified liquid resins. Best results are obtained using 50 - 75 % of the stoichiometric amount of hardener. The films cure rapidly at room temperature but can also be dried at elevated temperatures. Grinding of the pigments can be done in Beckocure EH 2260w or as well in shear stable epoxy dispersions (e. g.: Beckopox EP 2384w, Beckopox EP 386, Beckopox EP 387 or Beckopox VEP 2381w). The mill base temperature should not exceed 40 °C. The use of binder-free pigment pastes is recommended when the grinding temperature cannot be controlled. Dilution can be done with Beckocure EH 2260w or an epoxy dispersion.

BECKOPOX EM 460/60IBX is an excellent adhesion to steel and nonferrous metals, high corrosion protection, best recoatability. With polyvinylbutyral for one- and two-component washprimers, weldable shop primers. BECKOPOX EM 460/60IBX is used preferably in combination with polyvinyl butyral (PVB) for the production of wash primers and finish coatings. The ratio of Beckopox EM 460 to PVB should be 1 : 3 to 2 : 1. Wash primers based on this binder combination can be produced both as one-pack and two-pack systems. The solids content of primers based on polyvinyl butyral can be greatly increased by the use of Beckopox EM 460. It also improves adhesion and corrosion protection, especially in wash primers with chromate-free pigmentation. Primers based on the combination of Beckopox EM 460 with PVB cause no complications when overcoated with paints based on alkyd resins drying by oxidation, PVC mixed polymers, nitrocellulose and isocyanate-crosslinking acrylic resins. Even in the case of stoving enamels they cause no discolouration of the topcoat. Two-pack epoxy paints should be tested from case to case. Weldable shop primers Beckopox EM 460 is also suitable for the manufacture of weldable shop primers. In this case the PVB component should predominate in the combination. The effect of these primers on pore formation in the weld is slight, as is the odour problem, since no formaldehyde is given off.