S-06E is an electronic grade epoxy. It can be used as a casting resin, in LED encapsulation, insulating materials, 3D printing, carbon fibre cable cores and other composite materials, giving outstanding performance for UV resistance and anti-radiation properties. It is UV curable, thermal curable with anhydrides, high TG up to 195ºC, excellent yellowing resistance and good UV resistance, outstanding electrical insulation, low halogen and high purity and low viscosity.

S-21 is a distilled base epoxy resin for use in formulating UV-curable cycloaliphatic epoxide coatings systems. S-21 contributes to primary film properties. S-21 has both carboxylate and epoxy groups, with the potential for fast cure. S-21 is widely used in industry for the preparation of inks, resins, coatings, and encapsulation.

Beckopox EH 623W/80WA is a hardener for water-reducible coatings on mineral and metallic substrates, hydryaulic epoxy mortars (ECC). Beckopox EH 623W/80WA is used in combination with the water emulsifiable liquid resins Beckopox EP 122w, EP 147w and other liquid resins such as Beckopox EP 140, EP 116 and the solid resin dispersions Beckopox EP 384w and EP 385w (preferably in combination with liquid EP-resins) to produce water-thinnable paints hardening at room temperature with good adhesion to all mineral substrates.Drying at elevated temperatures (> 60 °C) should be avoided. At such conditions traces of acrylonitrile will be released. If the hardener is diluted with water there may be stability problems at solid concentrations of less than 20 %, especially at storage temperatures above 35°C. When pigments and fillers are being dispersed in the hardener, the temperature must not be allowed to rise above 40°C. These paints retain a constant gloss irrespective of thinning ratio or the time between mixing and the end of the pot life. Beckopox EH 623w may be used in combination with Beckopox EP 128 as an additive for hydraulic mortars, the mechanical properties of the cured system being considerably enhanced by the additive.

BECKOPOX EP 387W/52WA is an internally plasticized solid resin-Type 1-dispersion with improved shear stability, e. g. for water reducible fast drying anticorrosion primers and coatings for plastics.BECKOPOX EP 387W/52WA is an internally plasticized type 1solid epoxy resin as aqueous dispersion. Formulated together with adequate curing agents such as e. g. Beckopox VEH 2188w/55WA it is suited for corrosion protection primers with very good adhesion to most metallic substrates. It is also suitable for use in single coat and decorative systems for metallic substrates. For optimium corrosion protection it is recommended using 75 % of the stoichiometric curing agent quantity. Dispersion of pigments and fillers can be done in Beckopox EP 387w/52WA if the temperature does not exceed 40 °C. The formulated paint stability can be influenced by the additives used so that it is important to investigate their suitability thoroughly, such additves should not contain functional groups capable of reacting with epoxy groups.