S-06E is an electronic grade epoxy. It can be used as a casting resin, in LED encapsulation, insulating materials, 3D printing, carbon fibre cable cores and other composite materials, giving outstanding performance for UV resistance and anti-radiation properties. It is UV curable, thermal curable with anhydrides, high TG up to 195ºC, excellent yellowing resistance and good UV resistance, outstanding electrical insulation, low halogen and high purity and low viscosity.

S-21 is a distilled base epoxy resin for use in formulating UV-curable cycloaliphatic epoxide coatings systems. S-21 contributes to primary film properties. S-21 has both carboxylate and epoxy groups, with the potential for fast cure. S-21 is widely used in industry for the preparation of inks, resins, coatings, and encapsulation.

DUROXYN EF 900/60X is a superior adhesion, hardness and flexibility. High pigment loading, radiant gloss. Excellent resistance to temperature, water and alkali. Anticorrosive paint systems and primers. Zinc dust paints. DUROXYN EF 900/60X can be used as sole binder for air-drying and stoving paints or in conjunction with amine resins, for stoving primers and finishes. Air-drying paints Paints on Duroxyn EF 900 are tackfree within short time and have good through drying in normal film thickness. The films show good flexibility combined with excellent hardness and excellent adhesion, also to non-ferrous metals. Further advantages are resistance to water and diluted alkali. Duroxyn EF 900 is therefore excellently suited for paints, resistant to tropical climate, interior paints, zinc dust paints, and primer-surfacers. Stoving paints Duroxyn EF 900 can be used in the formulation of high quality stoving paints, either alone or in conjunction with low levels of amino resins, preferably melamine resins. The films afford top performance in terms of flexibility, hardness, impact resistance, adhesion to steel and non-ferrous metals, radiant brilliance high build and resistance to water and alkali. Such paints give primers and finishes which are resistant to tropical climate, or primers and fillers for e.g. the vehicle industry, with resistance to water and corrosion. The excellent adhesion and mechanical properties afford impact resistant enamels, e.g. primers-surfacers.

BECKOPOX EM 460/60IBX is an excellent adhesion to steel and nonferrous metals, high corrosion protection, best recoatability. With polyvinylbutyral for one- and two-component washprimers, weldable shop primers. BECKOPOX EM 460/60IBX is used preferably in combination with polyvinyl butyral (PVB) for the production of wash primers and finish coatings. The ratio of Beckopox EM 460 to PVB should be 1 : 3 to 2 : 1. Wash primers based on this binder combination can be produced both as one-pack and two-pack systems. The solids content of primers based on polyvinyl butyral can be greatly increased by the use of Beckopox EM 460. It also improves adhesion and corrosion protection, especially in wash primers with chromate-free pigmentation. Primers based on the combination of Beckopox EM 460 with PVB cause no complications when overcoated with paints based on alkyd resins drying by oxidation, PVC mixed polymers, nitrocellulose and isocyanate-crosslinking acrylic resins. Even in the case of stoving enamels they cause no discolouration of the topcoat. Two-pack epoxy paints should be tested from case to case. Weldable shop primers Beckopox EM 460 is also suitable for the manufacture of weldable shop primers. In this case the PVB component should predominate in the combination. The effect of these primers on pore formation in the weld is slight, as is the odour problem, since no formaldehyde is given off.