ROSKYDAL K 12 P is a binder for highly filled knifing fillers and stoppers for marble and stone. Fillers based on ROSKYDAL K 12 P cure fully whether applied in thin or thick coats. They are used in applications requiring hard adhesives and fillers. Formulation Combinations of talc, dolomite/calcite and powdered barytes with low iron content have proved suitable as extenders, with talc as the main component because it improves the adhesion to the substrate. The more spherical extenders such as dolomite, chalk and barytes ensure dense packing.

ROSKYDAL 300/1 is a formulation of clear and pigmented UV-curing top coats with very good flow properties for application by spraying and curtain coating. After the addition of photo-initiators, ROSKYDAL 300/1 can be cured under UV lamps. When using high-pressure mercury vapour lamps with a capacity of 80 - 120 W/cm lamp length, standard commercial initiators can be used. However, their suitability for the intended application should be tested, especially with respect to storage stability, reactivity and yellowing. The use of 2.5 % Irgacure® 17001 or Irgacure 6511 is recommended for clear coats (max. application rate: 250 g/cm2). In the case of top coats, Baysilone® Paint Additive PL2 should be used to promote the flow properties. The addition of 2 % of a 1 % solution in toluene is recommended. Pigmented coatings should be formulated using 2 % Lucirin® TPO1 or other suitable photoinitiators. All the quantities given are calculated on the resin supply form. Clear coats may contain soluble dyestuffs and highly disperse silicas. Primers are formulated using highly disperse silicas and quartz powder. Soluble dyestuffsmay also be added. The addition of 5 - 10 % Desmodur® L or Desmodur N improves the adhesion. However, such combinations have a limited pot life (approx. 24 hours with a 5 % addition of Desmodur L).

SETATHANE D 1145 is applied in the formulation of hard and tough coatings and synthetic resin mortars.It is used in combination with other polyols such as SETATHANE D 1150 and crosslinked with Desmodur VL, SETATHANE D 1145 is suitable for use in the formulation of two-component coatings. The main applications are in the construction industry. Curing yields hard to tough but flexible films which are resistant to abrasion and chemicals. In combination with other polyols such as SETATHANE D 1150 and crosslinked with Desmodur VL, SETATHANE D 1145 is suitable for use in the formulation of two-component coatings. The main applications are in the construction industry. Curing yields hard to tough but flexible films which are resistant to abrasion and chemicals.

SETATHANE D 1160 is applied in combination with solvent-free, predominantly aromatic polyisocyanates, as a binder for flexible floor coatings. It is the most suitable co-reactant for SETATHANE D 1160 is Desmodur VH 20 N. Other polyisocyanates such as Desmodur VL are also suitable but the compatibility must be tested in each case. SETATHANE D 1160 can be used in the formulation of flexible floor coatings. Coatings based on SETATHANE D 1160 and Desmodur VH 20 N are characterized by their high flexibility and good mechanical strength.