What Is Luna PTSI-P and How Does It Control Moisture in Polyurethane Formulations?
Luna PTSI-P reacts chemically with residual water before it can interact with isocyanate groups in the formulation. By consuming moisture at an early stage, it minimizes gas formation and secondary reactions that would otherwise compromise system stability.
Key functional effects include:
- More predictable curing behaviour
- Improved surface quality with reduced defects
- Enhanced mechanical consistency across batches
- Increased formulation robustness under variable humidity conditions
Because Luna PTSI-P reacts selectively with water, it supports moisture management without significantly altering the intended polyurethane network.
DKSH Performance Materials supports polyurethane formulators beyond ingredient supply by providing technical, regulatory, and formulation-level assistance throughout the product lifecycle.
| Contact us today for more information on Luna PTSI-P |
What are the recommended usage levels for Luna PTSI-P
Typical addition levels of Luna PTSI-P depend on the expected moisture content of the formulation and the sensitivity of the system.
General guidance:
- Low moisture systems: ~0.1–0.3 wt%
- Moderate moisture exposure: ~0.3–0.5 wt%
- High sensitivity or humid processing conditions: levels may be adjusted based on laboratory evaluation
Exact dosage should be optimized through formulation trials, considering raw material quality, storage conditions, and processing environment.
What formulation considerations should be taken into account?
When incorporating Luna PTSI-P into polyurethane systems, formulators should consider the following:
- Add Luna PTSI-P during the formulation stage where moisture exposure is most likely
- Ensure adequate mixing to achieve uniform distribution
- Evaluate compatibility with catalysts, fillers, and other reactive additives
- Monitor viscosity and pot life changes during optimization
Pre-testing under representative production conditions is recommended to confirm performance benefits.
What are the limitations of using Luna PTSI-P?
While Luna PTSI-P is effective for moisture scavenging, it is not a substitute for good manufacturing practices.
Limitations include:
- It cannot compensate for excessive or continuous moisture ingress
- Over-dosage may affect reaction kinetics or formulation balance
- Proper storage of raw materials remains essential
Moisture scavengers should be used as part of a broader moisture management strategy, including controlled storage and handling.
Where is Luna PTSI-P typically used?
PTSI-P is commonly applied in moisture-sensitive polyurethane applications such as:
- Coatings (industrial and protective)
- Adhesives and sealants
- Elastomers
- Construction materials
These applications benefit from improved consistency, reduced defects, and enhanced long-term performance.
What regulatory considerations apply to Luna PTSI-P?
Regulatory status depends on regional chemical inventories and application type. Formulators should verify compliance with relevant regulations, such as:
- REACH registration and usage conditions
- Local chemical inventory listings (e.g., TSCA, IECSC, AICS where applicable)
- Occupational safety and handling requirements
Safety data sheets and local regulatory guidance should be consulted before commercial use.
Frequently Asked Questions (FAQ)
1. Does Luna PTSI-P affect curing speed?
: PTSI-P primarily improves curing consistency rather than accelerating reactions. Any effect on cure profile should be evaluated during formulation testing.
2. Can Luna PTSI-P be used in one-component polyurethane systems?
: Yes, PTSI-P is particularly useful in moisture-sensitive one-component systems where shelf stability is critical.
3. Is Luna PTSI-P compatible with common polyurethane catalysts?
: In most cases, PTSI-P is compatible, but catalyst interactions should be assessed during formulation development.
4. Does Luna PTSI-P replace drying of raw materials?
: No. It complements, but does not replace, proper drying and moisture control practices.
Request Your Samples Today
About DKSH Performance Materials
DKSH Performance Materials is a leading distributor and solutions provider for specialty chemicals and ingredients. With deep technical expertise and a strong global network, DKSH supports customers in optimizing formulations and accelerating growth across industries.
